Summers Disk-Chisel - Manual (Page 64)

TRIP & SHANK INSTALL 8/17/2012 9CC3212.iam/
8K5515
3/4 X 4 X 6"
8X0118
3/4 X 4"
8X0306
3/4" LW
8X0260
3/4" N
8X0306
3/4" LW
8X0260
3/4" N
8T7500
700 LB TRIP (BLACK SPRING)
OR
8T7500H
1050 LB TRIP (GREEN SPRING)
8T0504 (GREEN)
8T0500 (BLACK)
2-52
SECTION 2 – INSTALLATION OF SHANKS AND COULTER GANGS
1. Install shanks into trip assemblies.
– Install rear 3/4 x 4” bolt. Slide shank into
shank holder. Install front bolt. Securely
tighten.
– Shanks will fit snuggly into shank holder. If
tapping bottom of shank does not work,
it may be necessary to remove burr and/
or paint from shank or shank holder.