Steffy Wood Products 16 Tray Storage Cabinet - Manual (Page 2)

2
(refer to sketch at right)
Slide the 1/4" thick shelves into the slots in side
panel. Be sure the slots in each shelf are facing
up.
Slide the 1/4" thick dividers into the slots in the
shelves, top and bottom panels. Be sure all
shelves and dividers are down the entire length
of each slot.
3
(refer to sketch below)
Slide the back panels into the slots in the top,
shelf, bottom and side panel. Be sure each
panel is completely in the slot in the
assembled side panel. The back panels may
be installed with the wood grain on the inside
or outside.
5
(refer to sketch at right)
Place the remaining side panel into position at the
end of the top, shelf and bottom panels. Insert a
connector bolt into each hole and partially tighten
to the top, shelf and bottom panel.
After the side is partially attached, stand the
cabinet upright and make sure the shelves and
back panels are in the slots in the side panel.
Completely tighten the connector bolts when all
panels are in place.
Go back and make sure all bolts are tight.
4
(refer to sketch below)
Attach the rubber bumper to the
pre-drilled hole in the bottom of the
cabinet using the 1" long screw.
IMPORTANT!
Check all connecting bolts periodically to
make sure they are tight!
DIVIDER
SHELF
BOTTOM PANEL
CENTER SHELF
TOP PANEL
BACK PANEL
SLOTS FOR BACK PANELS
1" LONG SCREW
BUMPER
BOTTOM PANEL
SIDE PANEL
CONNECTING BOLT