Steffy Wood Products 20-Tray Storage Cabinet - Manual (Page 2)

2
(refer to sketch at right)
Slide the 1/4" thick shelves into the slots in side
panel. Be sure the slots in each shelf are facing
up.
Slide the 1/4" thick dividers into the slots in the
shelves, top and bottom panels. Be sure all
shelves and dividers are down the entire length
of each slot.
3
(refer to sketch below)
Slide the back panels into the slots in the top,
shelf, bottom and side panel. Be sure each
panel is completely in the slot in the
assembled side panel. The back panels may
be installed with the wood grain on the inside
or outside.
4
(refer to sketch below)
Attach the rubber bumper to the
pre-drilled hole in the bottom of the
cabinet using the 1" long screw.
5
(refer to sketch at right)
Place the remaining side panel into
position at the end of the top, shelf and
bottom panels. Insert a connector bolt into
each hole and partially tighten to the top,
shelf and bottom panel.
After the side is partially attached, stand
the cabinet upright and make sure the
shelves and back panels are in the slots in
the side panel. Completely tighten the
connector bolts when all panels are in
place.
Go back and make sure all bolts are tight.
IMPORTANT!
Check all connecting bolts periodically
to make sure they are tight!
DIVIDER
SHELF
BOTTOM PANEL
CENTER SHELF
TOP PANEL
BACK PANEL
Slots for back panel
BUMPER
1" LONG SCREW
BOTTOM PANEL
SIDE PANEL CONNECTING BOLT