Agilent Technologies U2781A - Manual (Page 40)

28 U2781A User’s Guide
2 Features and Functions
it, then there will be a total of seven SCPI commands to
send to chassis and modules.
4 During this identification operation, the trigger bus is
used. Hence, any triggering activities on the backplane
would be blocked.
5 Prior to any triggering activities, you must stop the
configuration activity by sending the following command:
SYSTem:IDentity {0|OFF}
N O T E
• Do not execute the above mentioned steps when the USB modules are in the
process of acquiring data.
• You do not need to perform the above pre-configuration if you are using the
Agilent Measurement Manager software. You are only required to press the
“Refresh” button.
U2781A UG.book Page 28 Friday, November 25, 2011 10:51 AM