Dake Dura Press Force - 50 - Manual (Page 8)

3/29/2010 8
Wiring Instructions
WARNING!!!!
A licensed qualified electrician that follows all state and local laws must wire and install the electrics on
this machine.
110 Volt
WARNING!!!!!
This machine must have a designated 30 amp drop for 110 volts.
1. For 110 volts this machine is ready to plug in. The machine can be wired 220 volt single phase. Always
follow the wiring diagram provided in the motor cover when converting to 220 volt single phase. A cord
and plug that is rated for the specified voltage and amperage must be used. This rating is located on the
motor.
WARNING!!!!
It is the responsibility of the installer to make sure the motor is wired correctly for the voltage needed.
Damage to motor could result.
220 Volt single phases 17.2 amps
WARNING!!!!
A licensed qualified electrician that follows all state and local laws must wire and install the electrics on
this machine.
WARNING!!!!!
This Machine new is shipped out as a 110 volt machine. If the wiring must be changed to suit
220 volts single phase.
1. The leads on the motor must be changed to fit 220 volts 17.2 Amps, follow the diagram on the
motor.
2. Install plug and wire that fits the rating on the motor, this plug and wire must be rated for the
voltage and amperage listed on the motor.
Operation
WARNING!!!!!!
If a 110 volt power supply will be used. A designated 30 amp drop must be supplied; this press will not
operate correctly without the 30 amps.
1. Fill the reservoir with 3 gallons of Mobil DTE 24 hydraulic fluid or its equivalent AW 32.
2. Turn the on / off power switch (toggle switch) to the “on” position (up).
3. Move the control lever down, this will advance the ram in the downward position.
4. Release the control lever and the ram will stop moving.
5. Move the control lever handle to the up position and the ram will move up.