Dake Dura Press Force - 40/70/100 - Manual (Page 3)

Force 40 70 100 Ton
3
The operator and owner must read and understand all of the following warnings. It is the
responsibility of the employer to check that the following warnings have been understood
by the operator and maintenance personnel.
WARNING!!!!
Operator must never place hands in the area of the ram during pressing operations.
Do not use this press for pulling.
A machine not subject to maintenance and periodic structural inspection is a danger for
the operator and the persons working near by.
It is strictly forbidden to tamper with, modify or elaborate parts of the machine that alter
its regular operation.
During the phases of maintenance requiring guards to be removed, machine must be
locked out according to local and state laws.
This press is designed for one operator.
All work requiring the piece to be pressed to be supported by the operator is forbidden.
It is strictly forbidden to press, cut, draw and do anything else with pieces whose
dimensions or physical nature may explode or produce splinters.
DEFINITIONS
In this manual “right side”, “left side”, forwards, backwards, top and bottom refer to the operator
situated in front of the press with the power unit to there right.
Press Identification
The press is fitted with a rating plate fixed in a visible manner on the front as shown in Fig. 1
item 1 on next page. The Dake part number and serial number on the front name plate shown in
Fig. 1 item 2.