Dake Model Zip 30 - Manual (Page 7)

7
ZIP 30 - MUL ZIP 30 - MUL ZIP 30 - MUL ZIP 30 - MUL ZIP 30 - MULTI MODE TI MODE TI MODE TI MODE TI MODE
MACHINE FUNCTIONAL
PARTS
5.1 - Operating head or saw frame
- Machine part consisting of the members that transfer the mo-
tion (gearmotor, flywheels), and tension/guide (blade-guides,
blade tension slide) and lowering control (optional) of tool.
- Position the machine on a firm cement floor, maintaining, at
the rear, a minimum distance of 1000 mm from the wall; an-
chor it to the ground as shown in the diagram, using screws
and expansion plugs or tie rods sunk in cement, ensuring that
it is sitting level.
4.5 - Instructions for electrical connection
- The machine is not provided with an electric plug, so the cus-
tomer must fit a suitable one for his own working conditions:
1 - WIRING DIAGRAM FOR 4-WIRE SYSTEM FOR THREE-
PHASE MACHINE - SOCKET FOR A 16A PLUG
4.6 - Instructions for assembly of the loose parts
and accessories
4.7 - Disactivating the machine
- If the sawing machine is to be out of use for a long period, it is
advisable to proceed as follows:
1) detach the plug from the electric supply panel
2) loosen blade
3) release the arch return spring
4) empty the coolant tank
5) carefully clean and grease the machine
6) if necessary, cover the machine.
4.8 - Dismantling
(because of deterioration and/or obsolescence)
General rules
If the machine is to be permanently demolished and/or scrapped,
divide the material to be disposed of according to type and com-
position, as follows:
1) Cast iron or ferrous materials, composed of metal alone, are
secondary raw materials, so they may be taken to an iron
foundry for re-smelting after having removed the contents
(classified in point 3);
2) electrical components, including the cable and electronic ma-
terial (magnetic cards, etc.), fall within the category of mate-
rial classified as being assimilable to urban waste accord-
ing to the laws of the European community, so they may be
set aside for collection by the public waste disposal service;
3) old mineral and synthetic and/or mixed oils, emulsified oils
and greases are special refuse, so they must be collected,
transported and subsequently disposed of by the old oil dis-
posal service.
NOTE:since standards and legislation concerning refuse in gen-
eral is in a state of continuous evolution and therefore
subject to changes and variations, the user must keep
informed of the regulations in force at the time of dispos-
ing of the machine tool, as these may differ from those
described above, which are to be considered as a gen-
eral guide line.
4.4 - Anchoring the machine
STAND CONTOUR
MACHINE FRONT
W
ALL
A A
375
375
750
750 1000
35 35 680
SEZ. A - A
12
R = L1
S = L2
T = L3
PE = GND
Fit the components supplied:
-
Mount bar-stop rod
- Mount and align the roll supporting arm as per the
counter-vice table.
- Mount the coolant liquido holder.
5