Electrix EQ Killer - Manual (Page 9)

English... 9
Power Input: This input will accept the Electrix MOD power
adapter only. The unit is active as soon as power is applied.
Phono/Line Switch: When connecting a turntable set this
switch to Phono. For all other inputs set the switch to Line. If
your unit is sounding distorted or too quiet check to make sure
this switch is in the correct position. Note: All line level inputs
and outputs on the EQ Killer are nominal at +4dBu.
RCA stereo Inputs 1 & 2: Connect the output of your
turntable, synth or CD player here. You can connect two line
level devices or turntables to EQ Killer at one time. Because EQ
Killer has"dual path" architecture, there is no internal mixing of
the two inputs; instead there is an output for each input. This
preserves the ability to cue each signal source individually on
your mixer.
RCA stereo Outputs 1& 2: Connect a stereo cable from
here to your mixer input channel. If you have two inputs con-
nected to the EQ Killer you should connect both of EQ Killer’s
outputs to inputs on the mixer. Note that even though your
input may be from a turntable, EQ Killer’s outputs are line level
and should be connected to line level inputs on your mixer.
The Effects Loop: When you use the EQ Killers FX Loop,
the "killed signal" gets sent to your external FX processor, then
returns back to the EQ Killer. The "killed" signal with effects is
then mixed back into the "unkilled" part of the original signal.
This way you can isolate an instrument, apply outboard effects to
it, then return that effected sound back to your mix.
• Connect a stereo cable from the EQ Killer FX Send
jacks to the inputs of your outboard effect processor.
• Connect the outputs of the effect processor to the
EQ Killer FX Return jacks.
Grounding Post: Connect the ground wire from your
turntable here.
Cable Strain Relief: The power supply cable can be looped
around this to prevent stress on the power entry jack.
U Un nd de errs stta an nd diin ng g tth he e E EQ Q K Kiilllle err • B Ba ac ck k P Pa an ne ell