AT&T E1937B - Manual (Page 2)

NOTES:
1. Use only the power cord supplied with this product. If you need a replacement, call 1 (800) 222-3111.
In Canada, call 1 (866) 288-4268.
2. Be sure to use an electrical outlet not controlled by a wall switch.
Installation and setup
After battery installation, place each handset in the telephone base or a charger and allow
to charge for 16 hours before use. You can keep the battery packs charged by returning
the handsets to the telephone base or chargers after each use. When the battery is fully
depleted, a recharge takes about 12 hours. The average talk time on a fully charged bat-
tery is about eight hours depending on environmental conditions, and the standby time is
approximately four days.
Plug the battery
pack connector
into handset.
Place handset in base or
charger to charge for 16
hours before first use.
Caution: Use only the supplied rechargeable battery or replacement battery pack (part number 80-5848-00-00).
Press in and downward on
the tab to open the battery
compartment cover.
Slide battery compartment
cover up until it clicks closed.
Place the battery
pack and wires in
the compartment.
Plug the large power adapter
into an electrical outlet not
controlled by a wall switch.
Plug telephone
line cord into
telephone jack.