Axis Communications 290A - Manual (Page 4)

4 290A Installation Instructions
6. Now position the widget (10) inside the swivel (11) with the cables coming through
the opening. Match the F and R on the widget with the F and R on the swivel,
assuring that F remains at the front and R at the back.
7. Line up the positioning bolt (13) with the screw hole in the widget (10) and tighten it
using the large allen key (1).
8. Position the white rubber seal (9) on the
flat face of the swivel (11) by pushing
the power cable through the off centre
hole on the left and the network cable
through the off centre hole on the right.
The two off centre holes should be
positioned towards the back.
9. Position the housing (8) on the swivel
(11) with the white rubber seal (9) in
between, the network cable going
through the larger hole in the black
board and the power cable going
through the smaller hole. Attach the
housing to the swivel by tightening up
the four screws held in the swivel. Use
the small allen key (2) to do this.
Power
cable Network
cable
Two off centre
holes positioned
at the back
9