Operating the appliance, Note, Control panel – Siemens LI18030 User Manual

Page 12: Filter drawer, Setting the fan, Lighting, Cleaning and maintenance, Risk of burns, Risk of electric shock, Risk of injury

Advertising
background image

12

Operating the appliance

These instructions apply to several appliance variants. It is

possible that individual features are described which do not
apply to your appliance.

Note: Switch on the extractor hood when you start cooking and

switch it off again several minutes after you have finished
cooking. This is the most effective way of removing the kitchen
fumes.

Control panel

Filter drawer

Pulling out the filter drawer
Hold the filter drawer by the middle and pull it out.
The control panel is accessible and the appliance is ready for
operation.

Note: Start the appliance with the functions which were set

when the drawer was closed.
Pushing the filter drawer in
Hold the filter drawer by the middle and push it in.

Note: The ventilation is switched off when the drawer is closed,

the light stays on.

Setting the fan

Note: Always adjust the fan strength to meet current conditions.

If there is a large build-up of steam or fumes, select a high fan

setting.
Switching on
Press the

#

, 2 or 3 button.

Switching off
Press the

#

button.

Lighting

The lighting can be switched on and off independently of the

ventilation.
Press the

@

button.

Cleaning and maintenance

:

Risk of burns!

The appliance will become hot during operation, especially
near the bulbs. Allow the appliance to cool down before
cleaning.

:

Risk of electric shock!

Penetrating moisture may result in an electric shock. Clean the
appliance using a damp cloth only. Before cleaning, pull out the
mains plug or switch off the circuit breaker in the fuse box.

:

Risk of electric shock!

Penetrating moisture may cause an electric shock. Do not use
any high-pressure cleaners or steam cleaners.

:

Risk of injury!

Components inside the appliance may have sharp edges. Wear
protective gloves.

Cleaning agents

Observe the information in the table to ensure that the different
surfaces are not damaged by using the wrong type of cleaning

agent. Do not use

harsh or abrasive cleaning agents,

cleaning agents with a high concentration of alcohol,

hard scouring pads or sponges,

high-pressure cleaners or steam cleaners.

Wash new sponge cloths thoroughly before use.
Follow all instructions and warnings included with the cleaning
agents.

Explanation

N

Light On/Off

#

Fan Off/Fan speed 1

2

Fan speed 2

3

Fan speed 3

Advertising