Network configuration, Windows 95/98/nt4.0/me, Windows 2000/xp instructions – Avaya S8700 User Manual

Page 7

Advertising
background image

Job Aid

Issue 3

7

May 2003

Ideally, the laptop computer must have the following files available:

■

License and Avaya Authentication (password) files. These must be downloaded from the Remote Feature
Activation (RFA) Web site.

■

Software patches and new firmware. These can be downloaded from the Avaya Support Web site
(

http://avaya.com/support

); click on Software and Firmware Downloads.

Network Configuration

A new network connection must be configured as follows:

NOTE:

Write down the original settings in case you need to change them back.

Windows 95/98/NT4.0/ME

1.

On your desktop right-click Network Neighborhood > Properties to display the Network dialog box.

2.

In the window select the TCP/IP that corresponds to your Ethernet card.

3.

Click Properties.

4.

Select Specify an IP address:

5.

IP address: 192.11.13.5

6.

Subnet Mask: 255.255.255.252

7.

Click OK, OK to accept the information and close the windows.

8.

Reboot the computer to effect the changes.

Windows 2000/XP instructions:

1.

On your desktop (under Start for XP) right-click My Network Places > Properties to display the Network and
Dial-up Connections window.

Windows 2000 should have automatically detected the Ethernet card in your system and created a LAN
connection for you. More than one connection may appear.

2.

Right-click on the correct Local Area Connection > Properties to display the Local Area Connection
Properties dialog box.

3.

Select Internet Protocol (TCP/IP).

4.

Click the Properties button to display the Internet Protocol (TCP/IP) Properties dialog box.

5.

On the General tab, select "Use the following IP address." Enter the following:

IP address: 192.11.13.5

Subnet mask: 255.255.255.252

Make a note of any IP addresses or other entries that you have to clear. You may need to restore them later
to connect to another network.

Advertising