Kenwood K-323-BK - Manual (Page 24)

K-323
24
Playing a USB device
Program playback
Audio fi les can be played in the order programmed
by the user.
Select the USB source and enter stop mode.
1
Select "PGM" (program play mode).
Press [P.MODE].
Each press switches the playback mode.
Folder play mode
Program play mode PGM
lit
N lit
Normal play mode Not lit
2
Select a fi le.
Select the folder with [ G]/[H]
or [Numeric] buttons, and press
[ENTER].
Select an audio fi le with [ G]/
[ H] or [Numeric] buttons, and
press [ENTER].
Display when fi le 10 in folder 003 is programmed as
the 1st fi le in the program.
If you committed a mistake in selection, press
[CLEAR] on the remote control unit before
pressing [ENTER] and restart selection.
Up to 32 fi les can be programmed.
•
•
3
Start playback.
Press [USB E].
To clear a fi le from the program...
Stop playback and press [CLEAR] on the remote
control unit. Each press clears the last track in the
current program.
To add a fi le to the program after
programming...
If playback is underway, stop it and perform steps
2 and after.
To cancel the program mode...
Stop playback and press [P.MODE] to select the
normal play mode. The program is cleared at this
time.
The program is cleared when the system is turned
OFF or the USB device used in programming is
disconnected.
■
■
■
•