Kenwood K-731-B - Manual (Page 72)

72 R-K731
Troubleshooting
Symptoms Solution Ref. page
CD
A CD does not play back
when loaded.
z Load the disc correctly with the label side facing upwards.
z Clean the disc. (See <Care and Storage>.)
z Allow any condensation to evaporate. (See <Be careful
against condensation>.)
26
74
74
No sound output z Press the [CDE] key.
z Clean the disc. (See <Care and Storage>.)
26
74
Playback skips. z Clean the disc. (See <Care and Storage>.) 74
Some audio fi les can't
play back. z The system will not play audio fi les that are corrupted.
z Make sure the audio fi le is supported for playback on the
system.
23, 24
Delay until playback
starts. z There may be a delay prior to playback if there are large
numbers of folders.
28
TAG information is not
displayed correctly. z Refer to <Supported Audio Files> to check which TAG
information can be displayed on this system.
23, 24
Symptoms Solution Ref. page
Components connected to the D.AUDIO terminal
The main unit and remote
control cannot control a
Kenwood digital audio player. z Connect the player using the dedicated cable PNC-150.
z Check whether the connected model is compatible.
13
48
Symptoms Solution Ref. page
Remote control
The remote control does
not work. z Load new batteries.
z Use the remote control within its eff ective range.
17
17
Symptoms Solution Ref. page
USB
No sound output when a
USB flash memory or USB
audio player is connected. z Plug in the USB fl ash memory correctly.
z Connect the USB cable correctly.
z Check to make sure the USB audio player is turned on.
12
34
The iPod/iPhone does
not provide sound. z The iPod/iPhone is not properly connected. Remove the
iPod/iPhone from the system, and then connect it again.
32
The iPod/iPhone cannot
be charged. z The iPod/iPhone is not properly connected. Remove the
iPod/iPhone from the system, and then connect it again.
32
R-K731_E.indb 72 R-K731_E.indb 72 2011/10/07 14:08:52 2011/10/07 14:08:52