Holtkoetter 8520 - Manual (Page 2)

e-mail: [email protected]
www.holtkoetter.com
ASSEMBLY INSTRUCTIONS FOR
Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN. Holtkötter ® and Holtkötter Leuchten ® are registered trademarks of Holtkötter. All Rights Reserved.
© Holtkötter
Please make sure that the following parts for your wall sconce are enclosed:
A. 75 Watt frosted Halopin Bulb
B. Glass Shield (two attached to fixture)
C. Allen Wrench
D. Wall Sconce
IT IS FIRMLY RECOMMENDED THAT A LICENSED
ELECTRICIAN INSTALL THIS FIXTURE. DISCONNECT
POWER BEFORE SERVICING.
General Installation Instructions
1. D isconnect power to the outlet.
2. Using the allen wrench (C) provided, loosen, but
do not remove the two set screws (E).
3. Slide the universal crossbar strap (G) off of the
fixture.
4. Mount the universal crossbar strap (G) to the outlet
box before making the wire connections.
5. Connect the wires from the fixture with the wires in
the outlet box according to generally accepted
electrical standards
6. Slide the fixture back onto the
screws (H) attached to the
universal crossbar strap.
7. Retighten the set screws (E) to
secure the fixture to the crossbar
strap.
A
Install or Replace Bulb
1. Disconnect power to the wall sconce.
2. Using a flat head screwdriver, unscrew
the finished screw (F) located on the
glass shield. Remove the glass shield
(B).
3. Remove the old bulb if needed.
4. Insert the 75 Watt (max.) halopin bulb (A)
by pushing it gently down into the socket.
NOTE: BE CAREFUL NOT TO TOUCH THE
BULB WITH YOUR BARE HANDS.
5. Reinstall the glass shield using the
previously removed finished screw (F).
B
F
A
D
C
C
E
E
G
H
Halogen Wall Sconce
No. 8520