Holtkoetter C8410-R - Manual (Page 3)

205 Hardman Avenue South, South Saint Paul, MN 55075
Voice: (800) 899-5444 • Fax: (888) 552-8661
e-mail: [email protected]
www.holtkoetter.com
ASSEMBLY INSTRUCTIONS FOR
Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN. Holtkötter ® and Holtkötter Leuchten ® are registered trademarks of Holtkötter. All Rights Reserved.
© Holtkötter
LICHTSTAR Reflector
No. R-5900
CARE INSTRUCTIONS
Use only a soft, dry cloth to clean. If necessary, a slightly damp, soft cloth can be used to spot
clean. Do not use common household cleaners on lamps or fixtures, as the lacquer on the
outside of the brass may be damaged as a result. Enjoy your new Holtkötter lamp.
QUICK-CONNECT INSTRUCTIONS
1. Once the LICHTSTAR canopy has been installed,
the quick-connect feature completes the fixture.
2. Be sure to discard the nut (A) removed from
the canopy and universal backplate assembly,
referred to in Step 2 under the Mounting
Instructions. This will allow access to the threaded
stem (G) at the center of the canopy.
3. Insert the plug (E), located at the end of the
cable or reflector, into the center of the threaded
stem (G).
4. Slide the finished stem (D) over the plug (E) and
screw into place on the threaded stem (G).
Diagram shows Canopy C-8120 with a cable
assembly.
D
E
G
R-5900
5˝
BULB REPLACEMENT INSTRUCTIONS
1. Disconnect the power to the outlet box before servicing.
2. Unscrew the reflector (A) counterclockwise and remove with the defective bulb.
3. Screw the reflector (A) back onto the fixture.
4. Install a new bulb (B): 35 Watt/12Volt, Osram Decostar, GU 5.3
A
B
C-8110 R-5900 HBOB C-8120 R-5900 CHROME