Videotec UPTHT02 - Manual (Page 4)

EN - English - I
nstruc
tions manual
2
Preparing the 5
product for use
Any change that is not expressly h
approved by the manufacturer
will invalidate the guarantee.
UPT1SGRA000C
230V 50/60Hz 0.5A
IP66
sn: 108004370001 MADE IN ITALY
Fig. 03
The kit can only be installed in Pan&Tilt’s h
which report the "C" revision or later.
Refer to the label placed on the body
of the P&T as shown in the figure.
Safety precautions 5.1
before use
Before carrying out any technical work, l
disconnect the power supply and
then wait at least 30 minutes to allow
the heating system to cool down.
The kit has been designed specifically as g
an accessory for the ULISSE integrated
positioning unit; do not change the wiring
already done by the manufacturer.
Contents and unpacking 5.2
When the product is delivered, make sure that
the package is intact and that there are no
signs that it has been dropped or scratched.
If there are obvious signs of damage,
contact the supplier immediately.
Keep the packaging in case you need
to send the product for repairs.
Identification 4
Product description 4.1
and type designation
Upgraded heater for low-temperature use. Easy to
install inside the integrated ULISSE housing, it is able
to distribute heat more uniformly inside the housing.
Available in 2 types:
Fig. 01
UPTHT1 • - For versions with motorised lenses,
operation is guaranteed down to -30°C and
lenses are guaranteed down to -20°C.
Fig. 02
UPTHT2 • - For the version fitted with a
Sony module the minimum temperature
range of the ULISSE falls to -30°C.
Product markings 4.2
See the label attached to the outside of the package.