4 identification, 1 product description and type designation, 2 product markings – Videotec UPTIRPS120 User Manual

Page 4: 5 preparing the product for use, 1 safety precautions before use, 2 contents and unpacking, 3 safely disposing of packaging material, 4 preparatory work before installation, 1 drilling the box, 2 assembly on supports

Advertising
background image

EN - English - I

nstruc

tions manual

2

• 90 degree fitting for conduit with gaskets
• Straight fittings for conduit with gaskets
• Adapter with gasket
• Screws for fixing box
• Instructions manual

5.3 Safely disposing of
packaging material

The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
Bear in mind that if the material has to be returned
due to a fault, using the original packaging for its
transport is strongly recommended.

5.4 Preparatory work before
installation

5.4.1 Drilling the box

Drill the box for cable outlets, as required.

Fig. 01

5.4.2 Assembly on supports

The box can be fitted directly on the wall, using the
slots at the bottom of the box, as in the illustration.

Fig. 02

• The appliance should only be considered switched

off when the power supply has been disconnected
and the connecting cables to other devices have
been removed.

• Before connecting all the cables make sure the

device is properly connected to the earth circuit.

• The main switch must be easily accessible for rapid

intervention when needed.

4 Identification

4.1 Product description and type
designation

Light sensor IN 120Vac in weatherproof box for
ULISSE IR360

4.2 Product markings

See the label attached to the outside of the package.

5 Preparing the product
for use

h

Any change that is not expressly approved
by the manufacturer will invalidate the
guarantee.

5.1 Safety precautions before
use

g

For any technical work whatsoever, always
isolate the power supply before carrying
out any operation.

h

All work must be done only and exclusively
by qualified personnel and the installation
must be set up in accordance with the
legislation and standards in force in the
country where it is to be used.

5.2 Contents and unpacking

When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
Keep the packaging in case you need to send the
product for repairs.
Check the contents to make sure they correspond
with the list of materials as below:
• Waterproof box complete with conduit and cables
• 45 degree fitting for conduit with gaskets

Advertising