Alpine CDA-9855R - Manual (Page 42)

41
-EN
Installation
Caution
When you install this unit in your car, do not remove the
detachable front panel.
If the detachable front panel is removed during installation, you
might press too hard and warp the metal plate that holds it in
place.
Caution
Do not block the unit’s fan or heat sink, thus preventing air
circulation. If blocked, heat will accumulate inside the unit and
may cause a fire.
Metal plate
Detachable
Front panel
Air ventilation hole
(Rear of CDA-9855R/CDA-9853R)
1
Slide mounting sleeve from main unit (see
“Removal” on this page). Slide the mounting sleeve
into the dashboard and fix it with the metal
shackles.
2
When your vehicle has the Bracket, mount the long
hex bolt onto the rear panel of the CDA-9855R/
CDA-9853R and put the Rubber Cap on the hex
bolt. If your vehicle does not have the Mounting
Support, reinforce the head unit with the metal
mounting strap (not supplied). Connect all the
leads of the CDA-9855R/CDA-9853R according to
details described in the CONNECTION section.
• For the screw *, provide a proper screw to the chassis installing
location.
3
Slide the CDA-9855R/CDA-9853R into the
dashboard. When the unit is in place, make sure
the locking pins are fully seated in the down
position. This can be done by pressing firmly in on
the unit while pushing the locking pin down with a
small screwdriver. This ensures that the unit is
properly locked and will not accidentally come out
from the dashboard. Install the Detachable Front
Panel.
Removal
1 Remove the detachable front panel.
2 Use a small screwdriver (or similar tool) to push the
locking pins to the “up” position (see above drawing).
As each pin is unlocked, gently pull out on the unit to
make sure it does not re-lock before unlocking the
second pin.
3 Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
Dashboard
Rubber Cap
(Included)
Bracket
Mounting sleeve
(Included)
Hex Bolt
(Included)
this unit
∗
Metal Mounting Strap
Screw
Bolt Stud
Hex Nut (M5)
this unit
Screws (M5 × 8)
(Included)
Mounting Bracket
this unit
Front frame
Lock pin