Videotec HEK - Manual (Page 8)

EN - English - I
nstruc
tions manual
6
Preparing the 5
product for use
Any change that is not expressly h
approved by the manufacturer
will invalidate the guarantee.
Contents and unpacking 5.1
When the product is delivered, make sure that
the package is intact and that there are no
signs that it has been dropped or scratched.
If there are obvious signs of damage,
contact the supplier immediately.
Keep the packaging in case you need
to send the product for repairs.
Check the contents to make sure they correspond
with the list of materials as below:
Housing •
Housing equipment: •
Screws for camera •
Spacers •
Allen wrench •
Desiccant salt bag
•
Instructions manual •
Safely disposing of 5.2
packaging material
The packaging material can all be recycled.
The installer technician will be responsible for
separating the material for disposal, and in
any case for compliance with the legislation
in force where the device is to be used.
Bear in mind that if the material has to be returned
due to a fault, using the original packaging
for its transport is strongly recommended.
Identification 4
Product description 4.1
and type designation
Innovative weatherproof housing for indoor/outdoor
installations. Made of extruded aluminium and plastic
material, it is provided with an innovative opening
system which allows access to the housing’s interior;
the body and the sunshield slide forward and hang
in place, while the unit remains fixed allowing access
to the camera from all angles. Its dimensions make
it suitable for CCD cameras equipped with fixed
lenses. Sturdy construction at a light weight, HEK
has two mounting options at the same time: regular
(WBMA) or feed-through (WBOVA2) bracket.
Its weatherproof features are ensured by EPDM-
rubber gaskets and by 3 M16 metric cable glands
or by the sealing gaskets, when installed with
bracket with internal cable management. A
wide range of accessories is available, including
sunshield, heater and fan-assisted heater, blower
and camera power supply. Further, it is also possible
to install a blower including an air filter replacing
one of the cable glands (not suitable in case of
using the bracket with internal cable channel).
The accessories are supplied factory
installed or as simple upgrade kit.
The innovative concept allows the installation in
different environments, either outdoor or indoor.
Product markings 4.2
See the label attached to the outside of the package.