AMICA ZZM616W EN - Manual (Page 17)

15
A forgotten dish can be added any time before the detergent cup opens.
Open the door a little to stop the washing.
After the spray arms stop working,you can open the door
completely.
Add forgotten dishes.
Close the door, the dishwasher will run after 10 seconds. 4
3
2
1
Starting a wash cycle...
Draw out the lower and upper basket, then load the dishes and
push them back. Please load the lower basket first and
push it back then the upper one (see the section entitled
“Loading the Dishwasher”).
Pour in the detergent (see the section entitled “Salt,
Detergent and Rinse Aid”).
Insert the plug into the socket. The power supply is 220-240
VAC 50 HZ, the specification of the socket is 12 A 250 VAC.
Make sure that the water supply is turned on to full pressure.
If all the lights begin to glimmer, that indicates the machine is out of order, please turn off the
main power and water supply before calling a service.
2
3
4
NOTE:
Note: When you press the Start/Reset button to pause during washing,
the program light will stop blinking and the dishwasher will mooing
every minute unless you press the Start/Reset button to start.
When select 6 kinds of wash program
Turn the program Knob, the wash program will be changed as follows direction
Intensive->Normal->Eco->Rinse->Rapid->3in1;
If a program is selected, the response light will light. Then press the
Start/Reset button, the dishwasher begins to restart.
Premise:
Otherwise,
the detergent may have already been released, and the appliance
may have already drained the wash water. If this is the case, the detergent
dispenser must be refilled (see the section entitled " Loading the
Detergent " ).
Press start/Reset Button more than three seconds the machine will
be in stand by state ,then you can change the program to
the desired cycle setting (see the section entitled " Starting a wash cycle. . . " ).
NOTE: If you open the door during washing, the machine
will pause. When you close the door and press the start/reset Button,
the machine will keep on working after 10 seconds.
The program lights show the state of the dishwasher:
a) All program lights off---------------stand by
b) One of the program lights on----------pause
c) One of the program lights blinking----- run
You can modify the washing program, When
the dishwasher just runs for a short time.
1
Turning on the Appliance