MagTek EC2000 99875713 - Manual (Page 3)

0 - Table of Contents
ExpressCard 2000| Instant Issuance Card Personalization System | Programmer’s Reference (Windows SDK)
Page 3 of 21
SAFETY
This product has been evaluated by multiple safety certification agencies, including
Underwriters Laboratories (UL) and the United States Federal Communications
Commission (FCC Class A and Class B), and is designed to protect both the user and the
device. This document is written specifically to work in conjunction with these safety and
integrity features to protect the user and the device. It is very important to follow all steps
in the product documentation carefully, in the order in which they are described, and at
the recommended times. Failure to do so could result in personal injury, and / or cause
damage to the device, and / or void the product warranty.
SAFETY REQUIREMENTS
Caution: Never do any of the following:

DO NOT use a ground adapter plug to connect equipment to a power receptacle that lacks a ground
connection terminal.

DO NOT attempt any maintenance procedure that is not specifically described in this manual or any
other MagTek ExpressCard 2000 manual.

DO NOT remove any of the covers or guards that are fastened with screws. There are no operator-
serviceable areas within these covers.

DO NOT override or “cheat” electrical or mechanical interlock devices.

DO NOT use supplies or cleaning materials for other than their intended purposes.

DO NOT operate the device if you or anyone else has noticed unusual noises or odors.
Consider the following before operating the ExpressCard 2000:

Connect equipment to a properly grounded power source receptacle. If in doubt, have the receptacle
checked by a qualified electrician. Improper connection of the equipment’s grounding conductor
creates a risk of electric shock.

Only place the device on a solid surface that can safely support the device’s weight.

Be careful when moving or relocating the device. Use proper lifting techniques.

Use materials and supplies specifically designed for MagTek equipment. Using unsuitable materials
can cause poor performance, and in some cases may be hazardous, cause damage, and / or void the
device’s warranty.