Section 1. features and specifications, Configurations, Features – MagTek SWIPE & PARK User Manual

Page 9: Table 1-1. configuration

Advertising
background image

SECTION 1. FEATURES AND SPECIFICATIONS


The Swipe & Park Hybrid Reader supports both mag-stripe and smart card technologies. For
mag-stripe cards, the unit reads tracks 1 and 2, or tracks 1, 2, and 3. For smart cards, the unit
supports ICC 8-pin contacts for ISO smart cards with flex circuit attached.

CONFIGURATIONS

Configurations are listed in Table 1-1.

Table 1-1. Configuration

Part Number

Head

Head Position

Tracks

Comments

21155001

Single

Left Side

1,2,3

No Electronics

21155005

Single

Left Side

1,2,3

Circuit Board with USB and RS-232 Interface


FEATURES

Features of the Swipe & Park Hybrid Reader are as follows:

•

Continuous unibody chassis that consists of a magnetic swipe path in line with a smart
card reader section

•

Provides for mounting a dual or triple track magnetic read head in butterfly configuration

•

Contains an 8-contact smart card block in ISO location

•

Smooth swipe operation with minimal interference or obstruction to the user

•

Side pressure provided to keep the card from sliding away from smart card contacts

•

Molded index pins provided that accurately allow for positioning of PCB

•

Proper clearance provided for bowed, warped, and embossed cards

•

Chassis mounting options

•

Rugged design for installation in harsh and high traffic environments


And with the Electronics installed, the following additional features apply:

•

On board SAM (Security Access Module)

•

RS-232 and USB interfaces

•

On board intelligence for transporting large blocks of data using a defined protocol and
command set

•

Test LED

•

Program Flash upgradeable

1

Advertising