MagTek MT-215 TTL HALF CARD - Manual (Page 9)

3
SECTION 2. INSTALLATION
The installation consists of mounting and connecting the Reader.
MOUNTING
The Reader has three mounting holes with inserts for 3.0mm diameter, a thread pitch of 0.5mm,
and a depth of 6.0mm. The mounting holes and dimensions are shown in Figure 1-2.
Figure 2-1. Mounting Dimensions
Mount the reader by attaching three screws through a surface and into the three mounting inserts
shown in Figure 2-1. Connect cable connector to J1. Figure 2-2 shows orientation of the pins
and the orientation for inserting the card. Pin 1 is closest to the center of the PCB, and Pin 8 is
closest to the edge of the PCB.
NOT TO SCALE
48mm
1.890 in
24mm
0.945 in
INSERTS
M3x0.5Px6L
40mm
1.576 in
22mm
0.867in