MagTek MICRIMAGE RS232 - PC - Manual (Page 2)

The following is required for installation:
• MICRImage Unit
• Interface Cable
• Power Adapter
INSTALLATION
• Connect the DB25 cable to the MICRImage Unit.
• Connect the DB9 cable to the serial port on the PC.
• Connect the power supply to the MICRImage cable.
For a single PC, install the MICRImage cables shown as follows:
MICRImage
12 VDC
Power
Adapter
P/N 22410302
Caution
Do not place the MICRImage Reader within 6 inches of a computer
monitor or power supply. These devices may cause undesirable
interference with the check reading operation.
CHECK READING
Place Check Flush
Onto Entry Slot
Slowly Slide Check Forward
Until Reader Pulls Check In
1
2
MAGNETIC STRIPE CARD READING