Midco Unipower MPG Series User Manual

Unipower, Mpg series, Gas burners

Advertising
background image

BURNER MODEL

BILL OF MAT'L
NUMBER

SERIAL NUMBER #

WIRING DIAGRAM

FOR SERVICE CONTACT:

Name

Address

Phone

Date of Installation

Installation and Service Instructions

909

8471 51

Unipower

MPG Series

Gas Burners

S A F E T Y I N F O R M A T I O N T E R M S :

The following terms are used to identify hazards, safety precaution of special

notations and have standard meanings throughout this manual. They are printed in all capital letters using a bold type face
as shown below, and preceded by the exclamation mark symbol. When you see the safety alert symbol and one of the
safety information terms as shown below, be aware of the hazard potential.

DANGER

: Identifies the most serious hazards which

will

result in severe personal injury or death.

WARNING

: Signifies a hazard that

could

result in personal injury or death.

CAUTION

: Identifies unsafe practices which would result in minor personal injury or product and property damage.

Midco International Inc.

4140 West Victoria St. - Chicago, Illinois 60646
tel 773.604.8700 fax 773.604.4070
web www.midcointernational.com e-mail [email protected]

Q u a l i t y D e s i g n e d f o r P r o v e n P e r f o r m a n c e

WARNING: If the information in these instructions

is not followed exactly, a fire or explosion may result,
causing property damage, personal injury or death.

Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.

WHAT TO DO IF YOU SMELL GAS:

Do not try to light any appliance.
Do not touch any electrical switch; do not use any

phone in your building.

Immediately phone your gas supplier from another

building. Follow the gas supplier’s instructions. If
you cannot reach your gas supplier call the fire
department.

Installation and service must be performed by a

qualified installer, service agency or the gas supplier.

In the United States, installation must conform with local codes or in
the absence of local codes, with the National Fuel Gas Code, ANSI
Z223.1-latest edition
available from American National Standard
Institute. Further reference should be made to the recommendation of
your fuel supplier.
In Canada, installation must conform with local codes or in the
absence of local codes, with Installation Codes for Gas Burning
Appliances and Equipment, CGA Standard CAN/CGA 1-B-149.1
or 2.

WARNING: Additions, changes, conversions and service

must be performed by an authorized Midco representative,
service agency or the fuel supplier. Use only MIDCO specified
and approved parts.

INSTALLER: Inform and demonstrate to the user the correct
operation and maintenance of the gas utilization equipment.
Inform the user of the hazards of storing flammable liquids and
vapors in the vicinity of this gas utilization equipment and
remove such hazards. Affix this manual and associated
literature to the burner.

CODE COMPLIANCE IS THE SOLE RESPONSIBILITY OF THE
INSTALLER.

USER: Retain this manual for future reference. If other than
routine service or maintenance as described in this manual and
associated literature is required, contact a qualified service
agency. DO NOT ATTEMPT REPAIRS. An inadvertent service
error could result in a dangerous condition.

Advertising