Legacy Classic Furniture Nursery Convertible Crib 2960-8900 - Manual (Page 6)

Assembly Instruction 2960-8900 CRIB DAWSON'S RIDGE
Page 6 of 6
 Blot spills immediately, and wipe with a clean, damp, cloth.
 We do not recommend the use of chemical cleansers, abrasives, or furniture polish on our lacquered
finish.
 If the crib is to be stored, store in cool dry place and carefully package all original hardware to protect
from loss or damage.
 Check fasteners periodically for tightness. DO NOT over tighten. This may cause distortion or
breakage.
This Crib can be converted to a Full Size Bed with the purchase of Legacy Classic bed rail. You will be provided
4 pcs flat head bolt M6 x 13, 8pcs bolt M6 x 62mm, to attach the Bed rail into your Crib. Follow the instruction
below with two adults:
PARTS INCLUDED:
(L) Flat head bolts M6 x 13 – 4 pcs
(K) Hex bolt screws: M6 x 62 – 8 pcs
ASSEMBLY INSTRUCTIONS:
1. Disassemble your Crib or Toddler Bed/Daybed and set all pieces and hardware aside in an organized
manner.
2. Keep the Headboard and the Footboard upright.
3. Assemble the Side Rail to the Headboard and the Footboard with 8 bolts (K). To change the position of
the side rail, unscrew 4 bolts (K), line up the Side rail with the holes at the desired height and re-attach
the Side rail with the same bolts (K).
4. Insert the flat head bolts (L) into the upper hole of the Headboard and the Footboard to keep out of the
children’s reach
5. Tighten all connections. Assembly is complete.
THANK YOU FOR YOUR PURCHASE.
www.legacyclassickids.com
High Point, NC. 336 449 – 4600