AT&T 1726 - Manual (Page 3)

2
F E A T U R E S E T U P
Turn System On/Off
Press O to turn the system on or off.
The message window will display
information when the system is on.
Feature Setup
1 To enter Feature Setup mode, press and
hold
S until the system announces
“Selected announcement is…”
2 Press and release
S until the system
announces the feature you want to set.
3 Press and release or
until the system announces the setting
you want. Refer to the Feature
Summary for options.
4 Press and release
S to set up the
next feature listed on the Feature
Summary
— OR —
Press and release
X to exit
Feature Setup.
The new settings will be saved.
Feature Summary
Feature/System Announces Options
Announce Select Choose the announcement your callers will hear.
The system comes preset for announcement
A.
“Selected announcement is...” • Select announcement A, , or C when you want
the system to record callers’ messages. Select AO
(announce only) when you want the system to
play an announcement and then hang up.
• If you select announcement A, , or C and do not
record an announcement, the system plays the
pre-recorded announcement: “Hello. Please
leave a message after the tone.”
• If you select AO and do not record an
announcement, the system will answer after
10 rings and announce “No announcement.”
See “Record Your Announcement” under OPERATION
for recording instructions.
Number of Rings Choose how many times the line will ring before
the system answers a call. The system comes preset
to 4 rings.
“Number of rings is...” • Set for 2 to 7 rings, or choose Toll Saver 2/4 or Toll
Saver 4/6.
• When set to Toll Saver 2/4, the system answers
after four rings when you have no new messages
and after two rings when you do. Toll Saver 4/6
causes the system to answer after six rings when
you have no new messages and after four rings
when you do.
Audible Message Alert When this feature is on, the system beeps every 15
seconds when you have new messages. Audible
Message Alert comes preset to OFF.