Horner APG XL10e OCS - Manual (Page 3)

MAN0945-04-EN Specifications / Installation
__________________________________________________________________________________________________________________________________________________________________________
1/24/2011 Page 3 of 4 #1037
4.2 External DIP Switch Settings
MJ2 Pinouts in Half and Full Duplex Modes
4.3
Built-in I/O Details
Table - Ports and Functions
Functions Port 1 (MJ1) Port 2 (MJ2)
RS-232 ! !
Hardware Handshaking ! X
Programming ! X
Ladder function
controlled ! !
Serial Downloable
Protocols ! !
RS 485 Full duplex X !
RS 485 Half duplex ! !
Models Description Manual
HE-XV1E2
HEXT501C112 12DC in (4HSC), 6 Relay out, 4 Analog In
MAN0946
HE-XV1E3
HEXT501C113 12 DC in (4HSC), 12 DC out (2 PWM), 2 Analog in
HE-XV1E4
HEXT501C114 24 DC in (4HSC), 16 DC out (2 PWM), 2 Analog in
MAN0947
HE-XV1E5
HEXT501C115 12 DC in (4HSC), 12 DC out (2 PWM), 2 Universal
Analog In (T/C, RTD, mV, mA, V) & 2 Analog out (mA, V)
MAN0953
4.1 Serial Communications:
MJ1: (RS-232 / RS-485) Use for Cscape programming and
Application-Defined Communications.
MJ2: (RS-232 / RS-485) Use for Application-Defined
Communications.
As seen when looking at the side of the XL10 unit:
The DIP Switches are used for
termination of the RS-485 ports. The
XL10 is shipped un-terminated.
To terminate, select one of the DIP
Switches and configure it based upon
the option that is desired.
Pin MJ1 Pins MJ2 Pins
Signal Direction Signal Direction
8 TXD OUT TXD OUT
7 RXD IN RXD IN
6 0 V Ground 0 V Ground
5* +5 60mA OUT +5 60mA OUT
4 RTS OUT TX- OUT
3 CTS IN TX+ OUT
2 RX- / TX- IN / OUT RX- IN
1 RX+ / TX+ IN / OUT RX+ IN
1
8
* +5V 60mA Max
MJ2 Half Duplex Mode
Pin MJ2 Pins
Signal Direction
8 TXD OUT
7 RXD IN
6 0 V Ground
5* +5 60mA OUT
4 TX- OUT
3 TX+ OUT
2 TX-/RX- IN/OUT
1 TX+/RX+ IN/OUT
1
8
Pin MJ2 Pins
Signal Direction
8 TXD OUT
7 RXD IN
6 0 V Ground
5* +5 60mA OUT
4 TX- OUT
3 TX+ OUT
2 RX- IN
1 RX+ IN
1
8
MJ2 Full Duplex Mode
* +5V 60mA Max
SW1 -
ON enables MJ2 RS485 port termination (121 Ohms).
OFF disables MJ2 RS485 port termination.
SW2 & SW3 - ON places MJ2 RS485 port in half-duplex mode.
OFF places MJ2 RS485 port in full-duplex mode.
SW4 -
ON enables MJ1 RS485 port termination (121 Ohms).
OFF disables MJ1 RS485 port termination.
MJ1
MJ2
On
Off
On
Off
On
Off