Set per-cup quantity – Siemens TK76K573 User Manual
Page 48
46
de
en
Empty the container� The appliance is
ready to use once more�
Rinsing the filter simultaneously activates
the setting for the
Service - change filter
display�
The filter is no longer effective when the
Service - change filter
display appears,
or at the latest after two months� It needs to
be replaced for reasons of hygiene and so
that there is no build-up of limescale (this
could damage the appliance)� Replacement
filters can be obtained from retailers or cus-
tomer service (see “Accessories”)�
After every filter change the filter must first
be rinsed� Proceed as described at the be-
ginning of this section�
If no new filter is used, turn the water filter
setting to
Off
�
You can find detailed information about the
water filter in the enclosed filter instructions.
If the appliance has not been used
for a prolonged period (e�g� during
your vacation) the filter should
be rinsed before the appliance
is used again� To do this, simply
dispense a cup of hot water�
Further entries in the Settings menu:
> Descaling program
: If you want
to descale the appliance, press
start
stop (8) and run the descaling programme
(see “Descaling”)�
> Cleaning program
: If you want
to clean the appliance, press
start
stop (8) and run the cleaning programme
(see “Cleaning”)�
> Calc‘n‘Clean
: If you want to
descale and clean the appliance at the
same time, press
start stop (8)
and run the Calc‘n‘Clean programme
(see “Calc‘n‘Clean“)�
> Factory settings
: You can cancel
your own settings and reset the factory set-
tings� To activate the factory settings, press
start stop (8)�
The appliance can also be reset to
the factory settings as follows:
1� Switch the appliance off fully at the
power switch
O/I (1)�
2� Press
<
and
>
(3) at the same
time, hold them down, and switch the
appliance on again at the power switch
O/I (1)�
The factory settings are reactivated�
Set per-cup quantity
The per-cup quantity can be adjusted
individually to suit your cups� It can be set
separately for each type of drink and each
cup size�
1� To call up the default settings, keep
i
(7) depressed for at least
3 seconds�
2� Select
Per-cup quantities
with
>
3� Press
start stop (8)�
4� Select the type of drink with the rotary
knob (4)�
5� Press
>
�
6� Select the cup size with the rotary knob
(4)�
7� Press
>
�
8� Set the per-cup quantity with the rotary
knob (4)�
<
returns you to cup size and drink
selection� To quit the default settings, press
i
(7)� The settings are stored�
When the cup size is selected, the changed
per-cup quantity is shown graphically:
1x
*
1x
+
Coffee
Per-cup quantity reduced compared
with standard setting
Per-cup quantity increased compared
with standard setting
Standard