PHASE RESEARCH 2000 Series User Manual
Page 84
SECTION 13 - PARAMETERS PROGRAMMING
13-16
PHASE RESEARCH
USER GUIDE
18. Press
to move the cursor to the field that begins F REPEAT.
19. Press
to move the cursor to the field just to the right of @.
20. Press
or
to set the number of times you want the beep to repeat.
The Remote Display will sound two successive short beeps at intervals of 2, 5,
10, 15, or 30 seconds depending on your choice. (Select OFF to disable the
repeat beep.)
21. Press
to move the cursor immediately to the left of DAYS.
22. Press
to move the cursor to [A] (A means “All”), or to any of the days
to the right.
23. Press
or
to select the days to which you wish to copy the targets
you have set. Your selections are now highlighted.
24. Press
to move the cursor to the DAYPARTS field.
25. Press
to move the cursor to [A] (A means “All”), or to any of the day-
parts to the right.
26. Press
or
to select the dayparts to which you wish to copy the
targets you have set. Your selections are now highlighted.
27. Press
to perform the specified copy operation. Repeat this procedure as
needed for different targeted events.
28. Press
to move the cursor to the top of the screen to the
[TARGET], [DAY] and [DAYPART] fields.
29. Press
or
to scroll through the TARGET, DAY, and DAYPART
values to confirm your settings.