Allied Telesis 86241-06 - Manual (Page 28)

28 Patch Release Note
Patch 86241-05 for Software Release 2.4.1
C613-10340-00 REV E
■ ENABLE DS3 TEST
■ RESET DS3
■ RESET DS3 COUNTERS
■ SET DS3
■ SHOW DS3 CMTCE
■ SHOW DS3 CONFIGURATION
■ SHOW DS3 COUNTERS
■ SHOW DS3 DEBUG
■ SHOW DS3 STATE
■ SHOW DS3 TEST
Once the interface is set up and configured, it can be used in conjunction with
Frame Relay, using the following commands:
■ CREATE FRAMERELAY
■ SHOW FRAMERELAY
See Chapter 5, Frame Relay in your switch’s Software Reference.
DS3 interfaces can be tested with the test facility, using the following
commands:
■ DISABLE TEST INTERFACE
■ ENABLE TEST INTERFACE
■ SHOW TEST
See Chapter 7, Test Facility in your switch’s Software Reference.