iPazzPort SY-20-19VC-0 - Manual (Page 8)

Connecting and Powering on the Pearl Double
Sided Keyboard:
1. Holding the keyboard in your hand with the Keyboard/Touchpad
side up, slide the power switch down on the left hand side down
to “ON”.
2. Flip the keyboard over so that the Remote Side is facing up and
slide it into the opening on the top of the Pearl Command Center.
3. ONCE IN THE CHARGING TERMINAL, ALLOW THE KEYBOARD
TO CHARGE FOR 4-6 HOURS BEFORE CONTINUING USE.
Power swith
Connecting the Pearl to the Internet via Wired Connection:
If you are using a wired connection, simply plug one end of
an RJ 45 cable (NOT supplied) into your router or modem
and the other end into Port # 6
Connecting the Pearl to the Internet via WiFi Connection:
1. On the Remote side of the Pearl keyboard, press the “Settings”
button, which is the green button shown below.
2. Once in the “Settings” page, ensure that “Wi-Fi” is turned to “on”.
Available networks should populate on the right side of the screen.
If they do not, simply press the “refresh” button on the top right of
the screen.
3. Next, select the name of the network you would like to connect to.
Click once on the name and enter a password if necessary.
4. In the lower left hand corner, a “Wi-Fi” icon will appear and
your clock will automatically be adjusted to the current time.