Weems and Plath Endurance 125 Clock - Manual (Page 2)

ADDENDUM TO MOUNTING INSTRUCTIONS
1. Note the rear diameter of your instrument. If mounting 2 or more
instruments side by side ensure the center points are;
A )
apart by at least 1/2” more than the instrument rear diameter;
B) at least half the diameter (radius) plus 1” (25mm) below any
ceiling, shelf or other overhead obstruction; and
C) half the diameter (radius) plus 1/4” (6mm) above any lower shelf,
floor or table fixture.
Otherwise Slide ‘n Lock dovetail engagement cannot be made. If mixing
units of different sizes calculate horizontal center distance based on
the largest unit you intend to use.
2. Also ensure the center points are at least half the diameter (radius)
plus 1/4” (6mm) away from any side obstruction or corner.
3. If mounting 2 or more units vertically above one another, review items
1 & 2 (this section) regarding clearances to top, side and bottom.
Multiple center points must be at least one diameter plus 1/4”(6mm)
apart. If mixing units of different sizes calculate vertical center
distance based on the largest unit you intend to use.