Samlex America S600R User Manual
Samlex America Power suppliers
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- S600,S600R Series
- UL (UL458) Notice of Completion…………………..………………..
- Do not install the Inverter in a zero-clearance compartment.
- Overheating may occur.
- Do not operate the Inverter with damaged or substandard Wiring.
- To prevent from fire or explosion, do not put batteries, flammable materials, or anything should be ignition–protected around the inverter.
- A lead-acid battery may produce a short-circuit current who’s temperature is high enough to weld these metal items and cause a severe burn.
- This power inverter series is one of the most advanced line of mobile AC power systems.
- To get the most effective power inverter, it must be installed and used properly. Please read the instructions of this manual before you install and operate this model.
- Leave the switch in the down position (OFF) during installation.
- OVP：over voltage protection
- UVP：under voltage protection
- OTP：over temperature protection
- OLP：over load protection
- North America (GFCI)
- North America
- Continental Europe (SCHUKO)
- Australia / New Zealand
- United Kingdom
- 3-2-2. Ventilation Shaft：
- Be sure to keep it a distance (at least 1 inch) form surrounding things.
- Connect the input terminal to 12V / 24V / 48V battery or other 12V / 24V /48V power source.
- 【＋】represents positive, and【＊】represents negative. Reverse polarity connection will blow the internal fuse and may damage the inverter permanently.
- The dust can be inhaled into the unit when the cooling fan is working.
- Use the recommended wire lengths and sizes (see section 3-6).
- Do not mount the inverter where it will be exposed to the gases produced by the battery. These gases are very corrosive, and prolonged exposure will damage the Inverter.
- 3-4. Quick hook – up and testing：
- 3-4-3. Before proceeding further, carefully check that cable you have connected does tie negative terminal of inverter to the negative output power source.
- 3-4-4. Connect the cable from the negative terminal of the inverter to the negative terminal of the power source. Make a secure connection.
- 3-5. AC Safety Grounding：
- The ON / OFF switch turns the control circuit in the power inverter on and off. It does not disconnect power from the power inverter.
- The Inverter operates from an input voltage ranging of：
- UL (UL458) Notice of Completion…………………..………………..