Campbell Scientific 21108 RF450 Demo Kit - Manual (Page 9)

21108 RF450 Demo Kit
Choose an appropriate antenna for the base station (see Section 2). Attach the
antenna cable or whip antenna to the connector labeled Antenna Connection
(see Figure 3-3).
FIGURE 3-3. Antenna Connection with the Whip Antenna Attached
Once connected, the Master Radio should show a constant red light on the CD
LED (see Figure 3-1).
4. Remote Sites
The plastic enclosure containing the Slave Radio will be carried around to act
as the remote site (see Figure 4-1).
Before carrying the equipment to the remote sites, use the voltmeter to verify
that the battery is fully charged. If needed, recharge the battery via the wall
charger (see Figure 3-2).
LEDs on the slave radio indicate the quality of the connection (see Figure 4-1
and Table 4-1).
Try each antenna until you get an excellent connection. The Yagi antenna will
need to be aimed directly at the base station.
5