Campbell Scientific CDM-VW300 Series Dynamic Vibrating-Wire Analyzer System - Manual (Page 40)

CDM-VW300 Series Dynamic Vibrating-Wire Analyzers
FIGURE 7-2. DevConfig Settings Editor
Details about using DevConfig can be found in DevConfig Help or in the
LoggerNet datalogger support software manual, which is available at
www.campbellsci.com .
If a COM port CDM-VW300 does not appear in the available
selections for Communications Port, then there is a problem
with the installation of the device driver or the creation of the
COM port. See Section 7.1.1, Software and Driver Installation,
for remedial steps. NOTE
7.1.3.2 DevConfig Settings Editor
See TABLE 7-1, Summary of CDM-VW300 Configuration Settings, for a
listing of settings that can be viewed and edited with DevConfig.
7.2 Using the Datalogger
Outputs from the CDM-VW300 are captured by a CR3000, CR1000, or CR800
datalogger via the SC-CPI communications interface. A custom CRBasic
program written to capture and store device outputs is loaded into the
datalogger.
30