Campbell Scientific CS300 Silicon Pyranometer - Manual (Page 14)

CS300 Pyranometer
7.2 Mounting to an Instrument Mount
7.2.1 Required Tools
Tools required for installation on a tripod or tower:
Small and medium Phillips screwdrivers
1/2 in open end wrench for CM225 or 015ARM
Tape measure
UV-resistant cable ties
Side-cut pliers
Compass
Step ladder
7.2.2 Mounting Procedure
7.2.2.1 CM225 Solar Sensor Mounting Stand
1. If mounting the CM225 directly to a mast, place the CM225’s U-bolt in
the side holes and secure the CM225 to the mast by tightening the U-bolt
nuts.
2. If mounting a CM225 on a CM200-series crossarm, mount the crossarm to
the tripod or tower. Then place the CM225’s U-bolt in the bottom holes
and secure the CM225 to the crossarm by tightening the U-bolt nuts.
CM225 Stand
U-bolt Nuts
CM225 Stand
CM200-Series Crossarm
U-bolt Nuts
6