Campbell Scientific HUB-SDM8 8-Channel Hub for SDM Peripherals & Power Connections - Manual (Page 7)

HUB-SDM8
To CSAT3 Power
To CSAT3 SDM
To LI-7500 SDM
To LI-7500 Power
SDM In Power In SDM Out Power Out
FIGURE 2. HUB-SDM8 in a Daisy-Chain Network — Bottom View
5. HUB-SDM5
The HUB-SDM8 can provide the same function as the HUB-SDM5, which is a
5-channel hub for SDM peripherals. Use the supplied plugs to seal the unused
bulkhead fittings to use the HUB-SDM8 to connect multiple SDM devices to a
single Campbell Scientific, Inc. datalogger. Please refer to the HUB-SDM5
manual for connecting multiple SDM devices to a datalogger, using the
HUB-SDM8.
6. Generic Junction Box
The HUB-SDM8 can be used as a generic junction box. In its default
configuration, six eight-conductor cables can be connected to each other.
Three sixteen-conductor cables can be connected to each other by removing the
jumper between the terminal strips. Use a small screwdriver to pry the jumper
out.
3