Campbell Scientific HS2 and HS2P (HydroSense II) - Manual (Page 13)

HS2 and HS2P
The HydroSense II system consists of the items listed in TABLE 4-2,
HydroSense II Parts . These parts are shown in FIGURE 4-1, HS2 Parts in
Hard Carrying Case , FIGURE 4-2, HS2P Carrying Tote , and FIGURE 4-3 ,
HS2P Parts .
TABLE 4-2. HydroSense II Parts
Qty HS2 Part HS2P Part
1 HydroSense II measurement and display unit
1 HS2P Insertion Pole Assembly
(pn 29153)
1 CS658 (20 cm) or CS659
(12 cm) water content sensor
CS658P (20 cm) or CS659P
(12 cm) water content sensor
4 AA batteries (factory installed inside the display)
1 Spare battery holder (pn 28404); spare batteries not included
1 Wrench (pn 26156) for installing / replacing rods
1 Loctite thread locking compound (pn 13665) for rod replacement
1 Phillips screwdriver (pn 6290)
1 Hard carrying case (pn 27789) Carrying tote (pn 29468) or hard
carrying case (pn 27789)
1 HydroSense II Support Software (HydroSoft) on CD
FIGURE 4-1. HS2 Parts in Hard Carrying Case
CS658
Wrench
HS2 Display
Loctite
Spare
Battery
Holder
Screwdriver
5