Getting started – Campbell Scientific RAWS-P Remote Automated Weather Station User Manual
Page 10
RAWS-P Remote Automated Weather Station
Specifications are available from our web site at
For “sensors specifications,” click on “Products”, select “Sensors” and go to
the sensor manual for specifications. For “equipment specifications”, enter the
part number in the “Search” box on the website mentioned above and go to the
equipment manual for specifications.
Equipment and sensor specifications are provided on the
ResourceDVD which ships with the RAWS.
NOTE
2. Getting Started
Set up and test your station before field deployment.
Keep this manual and the CR1000KD Keyboard Display with
the RAWS.
NOTE
Review the station siting and orientation section before field deployment. If a
problem is encountered, review the equipment wiring and troubleshooting
sections in this manual.
After siting and leveling the RAWS station, open the enclosure and (1) connect
the battery cable and (2) verify the CH100 switch is in the ‘on’ position.
When this equipment is not in use (i.e., transport or storage),
disconnect battery cable to the CH100.
NOTE
2