Samsung PS58B850Y1W - Manual (Page 48)

English - 48
Troubleshooting for Anynet +
Symptom Solution
Anynet+ does not work. Check if the device is an • Anynet + device. The Anynet + system supports Anynet + devices only.
Connect only one receiver (home theater). •
Check if the • Anynet + device power cord is properly connected.
Check the • Anynet + device’s Video/Audio/HDMI 1.3 cable connections.
Check whether • Anynet + (HDMI-CEC) is set to On in the Anynet+ setup menu.
Check whether the TV remote control is in TV mode. •
Check whether it is • Anynet + exclusive remote control.
Anynet+ doesn’t work in certain situations. (Searching channels, Plug & Play, etc.) •
When connecting or removing the HDMI 1.3 cable, please make sure to search devices again •
or turn your TV off and on again.
Check if the • Anynet + Function of Anynet+ device is set on.
I want to start Anynet+. Check if the Anynet • + device is properly connected to the TV and check if the Anynet +
(HDMI-CEC) is set to On in the Anynet + Setup menu.
Press the • TV button on the TV remote control to switch to TV. Then press the TOOLS button
to show the Anynet + menu and select a menu you want.
I want to exit Anynet+. Select • View TV in the Anynet + menu.
Press the • SOURCE button on the TV remote control and select a device other than Anynet +
devices. (Note that the channel button operates only when a tuner-embedded Anynet+ device
is not connected.)
The message Connecting to
Anynet+ device...
appears on the screen.
You cannot use the remote control when you are configuring Anynet+ or switching to a view •
mode.
Use the remote control when the Anynet+ setting or switching to view mode is complete. •
The Anynet+ device does not
play.
You cannot use the play function when • Plug & Play is in progress.
The connected device is not
displayed.
Check whether or not the device supports • Anynet + functions.
Check whether or not the HDMI 1.3 cable is properly connected. •
Check whether • Anynet + (HDMI-CEC) is set to On in the Anynet + setup menu.
Search • Anynet + devices again.
You can connect an • Anynet + device using the HDMI 1.3 cable only. Some HDMI cables may
not support Anynet + functions.
If it is terminated by an abnormal situation such as disconnecting the HDMI cable or power •
cord or a power failure, please repeat the device scan.
The TV programme cannot be
recorded.
Check whether the antenna jack on the recording device is properly connected. •
The TV sound is not output
through the receiver.
Connect the optical cable between TV and the receiver. •
BN68-02334B-Eng.indb 48 2009-10-26 �� 11:36:07