Agilent Technologies Agilent 82350B - Manual (Page 27)

Installing and Configuring the 82350B 1
82350B Installation and Configuration Guide 15
2 Configure GPIB Card Parameters. When the Agilent
82350B PCI GPIB Interface dialog box appears, set the
VISA interface ID, SICL interface ID, Logical unit, and GPIB
address values as required.
Also, verify that this is the System controller for the GPIB to
which it is attached (this is the typical operating mode).
(See the System Controller discussion below.) Then, click
the OK button. Some guidelines to set these values follow.
Figure 1-12 Configure GPIB card parameters
N O T E
Changes to certain properties of the 82350B, including:
• GPIB address
• System controller flag
• SICL interface ID
• Logical unit
will not take effect until you reboot your PC. If you choose not
to reboot immediately, Connection Expert will display a
warning icon
until you reboot .