Samsung RFG23DERS - Manual (Page 15)

02 OPERA
TING
01 SETTING UP
Setting up _15
When moving your refrigerator
To prevent fl oor damage be sure the front
leveling legs are in the up position (above
the fl oor). Refer to ‘ADJUSTING THE
DOORS’ in the manual (at page 17)
FLOORING
For proper installation, this refrigerator must be
placed on a level surface of hard material that is
the same height as the rest of the fl ooring.
This surface should be strong enough to support
a fully loaded refrigerator.
To protect the fi nish of the fl ooring, cut a large
section of the cardboard carton and place under
the refrigerator where you are working.
When moving, be sure to pull the unit straight out
and push back in straight.
REMOVING THE REFRIGERATOR
DOORS
If the Refrigerator is too large to pass through your
doorway easily, you can remove the refrigerator
doors.
Tools you will need (Not provided)
Disconnect power to the refrigerator
before removing the door or drawer.
• Be careful not to drop, damage or scratch
the door/drawer while removing them.
• Be careful not to get injured while removing the
door/drawer.
• Reattach the door/drawer properly to avoid:
- Moisture from air leakage.
- Uneven door alignment.
- Wasting energy due to improper door seal.
Disassemble the Refrigerator doors
1. With the door opened, remove the Hinge Cover
cap 1 with a Flat head screwdriver, and close
the door. Remove the 3 screws holding down
the Hinge Cover and remove the Hinge Cover
2 .
2. Disconnect two connectors 3 at each side
of the top cap, the one connector 7 on right
side door and the other connector 4 on left
side door. Remove the tube 5 with pressing
the dark gray color part 6 of the water line
coupler.
If a red clip is on the coupler, it must be
removed before removing the tube.
2
1
WARNING
Philips
screwdriver
Flat-blade
screwdriver
Wrench(10 mm)
Pliers
Allen wrench
(3/16”) (5 mm)
5
6
4
3
3 3
5
4
7
Red Clip
(1/4")
DA99-03403B-10.indb 15 DA99-03403B-10.indb 15 2014. 7. 18. 8:01 2014. 7. 18. 8:01