Activeforever Spa2Go STG-1 - Manual (Page 20)

20
User’s Guide
Avoid punching too many holes in the bromine feeder, as
this could cause over bromination. This could bleach the
vinyl, and will void your warranty.
If the bromine level in the spa reaches 5 ppm or higher,
remove the bromine feeder from the spa until the bromine
level drops to the correct 2-3 ppm range.
Adding Chemicals
1. Always activate the turbo wave blower when adding chemicals to the spa.
Add only one chemical at a time.
Failure to properly dissolve or dilute chemicals prior to adding
them to the spa may damage the spa vinyl surfaces and will void
your warranty.
2. When adding chemicals, dip a few gallons of water from the spa into a
fi ve gallon bucket. Dissolve or dilute the chemicals in the bucket. Stir the
bucket until the chemicals are fully dissolved or diluted. With the turbo
wave blower turned on, slowly pour the bucket into the spa in the stream
of the water jets.
3. Do not use gas chlorination, chlorine tablets, ionizers, scents, salts, or
soaps without consulting your authorized dealer.
Cleanliness
1. Drain and refi ll the spa every three months, or when the water becomes
cloudy and is not cleared by proper water chemistry.
2. Remove and clean your fi lter at least once a week. A dirty fi lter will
prevent water fl ow and may prevent the spa from heating.
Vinyl Repairs
If the vinyl is torn or punctured, repair it with the patch kit provided with
your spa. A secure, unnoticeable repair can usually be made. Additional vinyl
pieces may be obtained through your authorized dealer.