Audiovox VE706 - Manual (Page 17)

16
SETTING and ACTIVATING ALARM
NOTE: The VE706 must be turned “OFF” when performing the following procedure.
1) Press the SET button twice to enter the alarm mode, press the P3 button to toggle between the
active and deactivated mode.
NOTE: If a series of dashes appear (--: --), the Alarm is DEACTIVATED.
2) Press the CH up/down buttons to set the desired hour/minute. When setting the alarm, check the
AM/PM indicator to assure the proper setting.
3) Press the SEEK buttons to toggle between the hours and minutes.
4) Press the On/OFF button. The alarm is now set and activated. Once the alarm is set it will sound
each day at the same time as long as it is activated.
DEACTIVATING ALARM
1) Press the SET button twice to enter the alarm mode.
2) Press the P3 button once. The set time will disappear from the Display Window and a series of
dashes (--: --) will appear, Alarm DEACTIVATED mode.
3) Press the ON/OFF button. The alarm is now deactivated.
NOTE: The set time will be stored in memory and can be reactivated whenever desired by
performing step 1) of the ACTIVATING ALARM procedure.
SETTING THE ALARM TONES
1) Press the SET button twice (power off).
2) Press the P4 button once to hear the alarm tone.
NOTE: Alarm must be in the “Activated” mode to hear tones.
3) Each time CH UP/DOWN button(s) is pressed it will select a different alarm tone.
4) Press the ON/OFF button to confirm the selected tone.
5) When the alarm sounds, press the set button to turn it off.
SETTING THE CABLE TV MODE
1) Press the SET button three times to enter the TV/Cable configuration mode.
2) CABLE or AIR will appear on the display.
3) Press the SEEK button to select Cable mode.
4) Press the CH UP/DOWN button(s) to select the desired cable mode (STD/IRC/HRC).
5) When the desired mode is reached, press the ON/OFF button to confirm.