AT&T 8110 - Manual (Page 34)

Speakerphone (for 8110 Users)
Allows you to place and answer calls without lifting the handset. Use
any time you prefer hands-free communication, both speaking and
listening, or for group conference situations.
To place/answer a call without lifting the handset
1 Press [ Spkr ]
● Red light goes on next to button
2 Place or answer call
● Adjust speakerphone volume with sliding arm on right of set
3 Press [ Spkr ] again to hang up
● Red light goes off
To prevent other party from hearing you (To mute microphone)
1 Press [ Mute ]
● Red light next to [ Mute ] goes on
● Other party cannot hear you
To resume talking to other party
(To turn on speakerphone microphone again)
1 Press [ Mute ]
● Red light next to [ Mute ] goes off
2 Resume conversation with other party
To change from speakerphone to handset
1 Lift handset and talk
● Red light goes off next to [ Spkr ]
To change from handset to speakerphone
1 During a call using handset, press [ Spkr ]
● Red light goes on next to [ Spkr ]
2 Hang up handset
30
Appendix A
Adjunct Equipment Installation Instructions
(For the 8102 Telephone Only)
Important: The installation of adjunct equipment (such as the AT&T
S201A speakerphone or a 500A Headset Adapter) with the 8102
telephone is different from installation with other telephones.
Use the following procedure for connecting adjunct equipment to the
8102 telephone. (See Figure 12.)
Note: Although an S201A Speakerphone is shown in Figure 12, a
500A Headset Adapter is connected to the 8102 telephone in the same
way.
1
2
3
4
Plug one end of the adjunct cord into the adjunct equipment.
Plug the other end of the adjunct cord into the Adjunct jack on the
rear of the 8102 telephone.
Plug one end of the adjunct power cord into the Adjunct Power jack
on the bottom of the 8102 telephone.
Plug the free end of the adjunct power cord into the adjunct power
supply.
31