Aarrow Fires Becton 7 mk3 - Manual (Page 19)

Becton Bunny & Becton 7 mk3 Gas stoves 19
SERVICING
DOOR TRIM
Becton Fire doors are fitted with a brushed steel
finish trim as standard. The trim is secured using 3
off tabs and located in the slot section of the trim
and secured with 3 off nuts. (See Fig. 11a below.)
Fig. 11a Location of the 3 off tabs
Note! To fit a tracery the trim must first be
removed. The fire door can only be fitted with one
item at a time.
REPLACEMENT OF THE DOOR
TRIM
Ensure the appliance is cold.
Step 1 Remove the fire door.
This is carried out by opening the door (secured
with a magnet) and lifting it off its hinges.
Fig 11b Lifting the door off its hinges
Step 2 Place the door on a flat surface and remove
the single tab. The tracery can now be removed.
(See Fig. 11c below)
Fig. 11c Untightening the single tab
Step 3 The trim will now lift off the remaining 2
tabs. See Fig. 11d.
Step 4 Repeat the above steps in reverse to replace
the trim.
FIRE DOOR GLASS & SEAL
If necessary the glass and seal can be removed as
follows:
Ensure the appliance is cold.
Step 1 Open the fire door.
Step 2 The glass frame is secured using M5 screws.
Remove all but the bottom 2 screws. See Fig. 12
below.
Fig. 12 Removing the Glass Frame
Step 3 Loosen the two remaining screws to enable
you to lift off the glass frame and the glass and
gasket assembly together.
To re-fit the glass & seal. First ensure sealing faces
are clean and free from dust. Then follow the
removal steps in reverse.
Note! The screws must be firmly secured to reform
the seal.
Fig 11d