Samsung RB215ACBP-XAA - Manual (Page 11)

Before You Install the water line
• The water line installation is not warranted by the refrigerator manufacturer.
So before you install the water line, read the whole steps for installing and follow these instructions
carefully to minimize the risk of expensive water damage.
• Banging pipes (water banging in the pipes) in house plumbing can cause damage to fridge parts and
lead to water leakage or flooding. Call a qualified plumber to correct the problem before installing the
water supply line to the fridge.
• To prevent burns and product damage, do not hook up the water line to the hot water line.
• Do not install the water line in areas where temperatures fall below freezing.
• When using any electrical device (such as a power drill) during installation, be sure the device is
insulated or wired in a manner to prevent electric shock.
• All installations must be in a accordance with local plumbing code requirements.
Connecting to water supply line
• Shut off the main water supply line and turn the Ice maker
to the off position.
• Locate the nearest cold drinking water line.
• Follow the instructions in the water filter installation kit.
• After connecting the water supply line to the Cartridge
Holder inlet and installing the Filter Cartridge (insert plastic
line in fully).
• Turn on water supply and Flush 3 gallons through filter
before use (flush approximately 6 minutes)
• Water line Kit and water filter are not covered by Samsung’s Warranty. The manufacturer (or dealer,
installer) of them is responsible for any defects and all the loss caused by water filter & water line
kit .
• The filter should be replaced should be replaced according to manufacturer (or dealer)’s
instruction.
• To order additional water filters, please contact the manufacturer (or dealer) of the filter.
• The water filter must be installed outside the refrigerator.
It is not provided with your new refrigerator. The filter cartridge
(
8) and holder (9) kit can be purchased from the retailer where
you purchased this refrigerator.
• Do not use copper line.
• Cut the tubing, making sure the ends are square and clean.
01
SETTING UP
90 degree
1. Cold Water line
2. Pipe Clamp.
3. Plastic line
4. Compression Nut
5. Compression Sleeve
6. Packing Nut
7. Shut Off Valve
8. Filter Cartridge
9. Cartridge Holder
Using the water filter (not provided)
Incorrect Correct
Setting Up _11
FLOORING
For proper installation, this refrigerator must be placed on a
level surface of hard material that is the same height as the
rest of the flooring. This surface should be strong enough
to support a fully loaded refrigerator, or approximately
223lbs(106kg). To protect the finish of the flooring, cut a
large section of the cardboard carton and place under
the refrigerator where you are working. When moving the
refrigerator, be sure to pull it straight out and return it to
position by pushing it straight in.
INSTALLATION OF THE WATER LINE