Reattaching the refrigerator doors, Disassemble the freezer drawer – Samsung RFG298HDRS-XAA User Manual

Page 7

Advertising
background image

setting up

_07

01

SETTING

UP

CAUTION

2. Disconnect one connector ( 3 ) on the right side door

and one connector (

4 ) on left side door. To remove

the water coupler from the hinge, twist and pull it from

the hinge. Remove the water line (

5 ) while pressing

the marked part (

6 ) of the water line coupler.

If a red clip is on the coupler, it must be
removed before removing the tube.

3. Pull and remove the hinge lever ( 7 ). Remove the

ground screw (

8 ) attached to the upper left and

right door hinges with a philips screwdriver (+).

Remove the upper left and right door hinges (

9 ).

4. Lift the door straight up to remove.

5. Remove the screw ( 10 ) attached to the lower left

and right door hinges with a philips screwdriver (+).

Remove the 2 hex head bolts (

11 ) attached to

the lower left and right door hinges with an allen

wrench (3/16”). Remove the lower left and right

door hinges (

12 ).

CAUTION

4

5

6

3

Red Clip

(1/4")

7

8

9

Slot

Slot

3

1

2

REATTACHING THE REFRIGERATOR DOORS

To reattach the fridge doors after you have moved the
fridge to its final location, assemble parts in reverse order.
1. The Water Line must be fully inserted to the center

of transparent coupler (Type A) or the line(Type B) to

prevent water leakage from the dispenser.

2. Insert the clip in the install pack and check that it

holds the line firmly.

DISASSEMBLE THE FREEZER DRAWER

1. Take out the upper drawer

by lifting it up.

2. Remove the tilting pocket

(

1 ) by pulling both support

guards (

2 ) upward at the

same time.

3. Take out the lower basket

(

3 ) by lifting the basket up

from the rail system.

4. Remove 4 hex head bolts

from both sides with a socket
wrench (10mm).

5. Lift up the freezer door from

the rails.

Putting too much food into the freezer drawers

can prevent the freezer from closing completely

and can cause frost build-up.

Allen wrench

12

10

11

Center of Transparent coupler

The Guide Lines

Dispenser

clip A (1/4”)
(6.35 mm)

clip A (1/4”)
(6.35 mm)

Type A

Type B

DA68-02488A-11.indb 7

14. 5. 14. �� 11:45

Advertising